Flooring Contractor in Ceres, CA - Floors That Start With a Sound Slab
Atwater Epoxy Floors and Concrete is a flooring contractor based in the City of Atwater. In Ceres, we coat, polish and resurface concrete in garages, patios and basements, and on shop and kitchen floors for small businesses.
- Licensed and insured.
- Free quotes on site.
- Replies within 1 business day.
Ceres floors and the slabs we find under them
Ceres sits in the middle of Stanislaus County, a short drive up the valley from our base in the City of Atwater. Most of what we see here is single-family homes with attached garages, plus shops, small warehouses and food businesses. Garages in the older neighborhoods near the center of the city have taken decades of cars and oil. Slabs in the newer subdivisions are cleaner, but they often still carry the sealer or curing compound that went on when the house was built. It's much the same mix we work on in Turlock and Keyes.
So on most Ceres jobs, what's already on the concrete and how sound it is underneath decide the floor, and that's what I check before we talk about colors or finishes.
Flooring and concrete services we offer in Ceres
Epoxy Floor Coatings
A good fit for Ceres garages and workrooms where you want a tough floor that's easy to clean, as long as we grind the slab first so the epoxy bonds.
Commercial & Industrial Epoxy Floor Coatings
Ceres shops and warehouses take forklifts, carts and spills, so we lay thicker systems over a slab prepped the way commercial floors need.
Garage Floor Coatings
Ceres garages often have older slabs with oil stains, old paint or patched cracks, and we clean and repair all of that before any coating goes down.
Polyaspartic Floor Coatings
When you need the garage or shop back quickly, a polyaspartic topcoat cures faster than standard epoxy, which suits households and businesses that can't close for long.
Metallic Epoxy Flooring
For a Ceres showroom or home bar, metallic epoxy gives a swirled, glossy look, but it shows every flaw, so the slab has to be flat first.
Urethane Cement Flooring
Ceres restaurant kitchens that see hot water, grease and daily washdowns are where we'd pick urethane cement, because it takes heat and moisture better than epoxy.
Polished Concrete Flooring
On a sound slab in a Ceres shop, office or house, polishing grinds the concrete itself to a shine, so there's no coating to wear through or peel.
Stained Concrete Flooring
Stain soaks into the concrete for a mottled, earthy color. That suits Ceres patios and indoor slabs where you'd rather keep the look of concrete than cover it.
Terrazzo Flooring
For a Ceres lobby, storefront or entry that takes heavy foot traffic, terrazzo sets stone or glass chips in a binder that we grind and polish smooth.
Basement Flooring
Where a Ceres house or building has a basement, we test the slab for moisture coming up from the ground before picking a floor that can handle it.
Concrete Grinding & Surface Preparation
Most floors we put down in Ceres start here. Grinding off old sealer, paint and the smooth top layer gives the new coating bare concrete to grip.
Concrete Sealing
A clear sealer suits Ceres driveways, patios and garage floors when you want them protected from oil and stains without changing much about how the concrete looks.
Concrete Resurfacing & Overlays
When a Ceres patio or walkway is worn, pitted or flaking but still solid underneath, an overlay gives it a new surface without tearing out the slab.
Self-Leveling Concrete & Overlays
When an older Ceres slab has dips and low spots, we pour a self-leveling layer first, so tile, wood or a coating goes down on a flat floor.
Pool Deck Coatings & Resurfacing
Backyard pool decks in Ceres take bare feet, pool water and chemicals, so we resurface or coat them with a textured finish that gives wet feet more grip.
Concrete Floor Stripping & Removal
When a Ceres floor still has old tile, carpet glue or a peeling coating on it, we strip it down to clean concrete before anything new goes on.
Get a free written floor estimate in Ceres
Send the form and we'll reply within one business day to set a time. I come out to check your concrete and measure, and the written estimate is free, with no obligation.
(209) 203-1590- Based in
- City of Atwater, CA 95301
- Hours
- Mon–Fri: 6 AM–10 PM, Sat–Sun: 8 AM–10 PM
Permits, licenses and pricing for Ceres floor jobs
The City of Ceres issues building permits here, and a job that needs one can't start until the permit is issued. That's the main way a permit changes your schedule. If your job needs a permit, we tell you at the estimate and handle it with the city. Before you hire anyone in Ceres, check two things. The contractor should hold a California license from the Contractors State License Board, and a Ceres business license, which the city requires for doing business inside its limits. We're licensed and insured.
Price and schedule both turn on the slab. That means its size, what has to come off it, how much crack repair it needs and which system you choose. Any permit adds time, and so does the cure time the coating maker sets before the floor goes back into use. I measure all of that at the estimate and put it in writing, step by step, the same way we do for customers in Atwater and McSwain.
What wears out Ceres garage and shop floors
Older garage slabs around Ceres usually carry years of oil drips and tire marks, and plenty have a coat of garage paint that's started to lift at the edges and where the tires sit. We grind that off, clean the oil out and fill the cracks before anything new goes down, because I won't put a floor on concrete I don't trust.
Shops, restaurant kitchens and small warehouses here take forklifts, carts, spills and washdowns that wear through a thin coating fast. For those floors we match the system to the traffic, which is the work I did for years on commercial floors before I started this business in 2017.
What to expect when you call us about a Ceres floor
From your first call to the final walk-through, here's how a Ceres floor job runs and who you'll be dealing with at each step.
Call us or send the form
Call (209) 203-1590 or use the form to tell us about the floor and how you use it. We set a time for me to come out and see it in Ceres.
I look at your slab
I come out myself to check the concrete for old coatings, oil, cracks and moisture, and to measure, so it helps if you're there to show me any trouble spots. You get a written estimate that lays out the prep, the system and each step in order, so nothing about the price is a surprise later.
Our crew does the work
A small crew I trained preps and coats the floor to the plan in your estimate, and I check the work as it goes. You don't need to be home, but the floor has to stay clear until the coating has cured.
We walk the floor together
I go over the finished floor with you before we call the job done, and tell you when it's ready for foot traffic and cars. The work is backed by our satisfaction guarantee.
Questions about flooring contractors in Ceres
Does my floor coating project need a building permit in Ceres?
It might. Ceres requires a building permit for almost any work done to a structure, and the only exceptions it lists are cosmetic jobs like paint, carpet and floor coverings. The city's building permit list gives examples, not a full list, so I don't assume a coating, overlay or slab repair is covered by it. I tell you at the estimate whether your job needs a permit, and when I'm not sure, we ask the building office before we start.
Who inspects building work in Ceres?
Stanislaus County does, because the city contracts with the county for all inspections and plan checks. Plans still go to Ceres, and the permit is issued from Ceres. If your floor job needs a permit, we handle it with the city.
Does a flooring contractor need a state license in California?
In most cases, yes. California requires a contractor's license when a project needs a building permit, when it uses any extra workers, or when the contracts on it total $1,000 or more in labor and materials. A larger job can't be split into smaller contracts to get under that $1,000 mark, so ask any contractor you're considering for their state license.
How do I find out if my Ceres home is in a flood zone?
You check your own property against the county's updated flood maps. FEMA updated the maps for Stanislaus County in 2020, and the county says the changes may affect building or insurance requirements. The Tuolumne River runs along the north edge of Ceres, and Stanislaus County's floodplain management page explains the map changes. If your property is in a mapped flood area, tell me at the estimate so we can ask the building office whether it changes anything for your floor.
What makes a garage floor coating cost more in Ceres?
Prep usually moves the price more than the coating does. An older Ceres garage with peeling paint, oil soaked into the concrete or a lot of cracks takes more grinding and repair before anything goes down. The system you pick matters next, since a multi-coat floor with flakes and a polyaspartic topcoat takes more material and labor than a single coat of clear sealer. Your written estimate shows each of those steps, so you can see where the money goes.
What causes epoxy garage floors to peel in Ceres homes?
Most peeling comes from poor prep. Coating rolled onto smooth, oily or already-sealed concrete sits on top of the slab instead of bonding to it. Moisture coming up through the slab can also push a coating off, which is why I check the concrete before I recommend anything. If your slab isn't ready for a coating, I'll tell you.
City of Atwater, CA
Tell us about your Ceres floor project
Call (209) 203-1590 or use the form to describe the floor and ask about permits, so I know what to check before I come out.